Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Working position
• Operation only with closed protection covers (5a)
Safety Precaution!
h...
see supplement-A1 Pkt. 7.), Be.- Bh.)
~
Changing from transport position to working
position is only to be carried out on even, firm
ground.
Starting position for lowering the cutter bar
1.
Implement is attached to tractor
- see chapter "Attaching implement to tractor"
2. Brace(8) pinned in position "Ba"
3. Jack stand (5) is pushed in and secured
,....
J:
ARBEITSSTELLUNG /9600-GB (368)
- 9-
Warkingposition
@
Changing to working position
Swinging the cutter bar down.
1. Makesurethatswivel"":"&&
I
~
I
1s free and that nobody 1s
~
*"q-
standing in the danger
'7J...
~
area.
"'-'1>44~%~
2. Raise stop-lock support using rope (S)
- Put hydraulic control device r--::~~~~-~
(ST)briefly at "Iift", in so doing the
fixing of the stop-lock support is
eased in the catch.
- Stop-lock support to position "B"
TD39196/19
3. Lower cutter bar hydraulically to the ground
- release rope (S) during lowering
4. Set height of Iifting gear (H1)
This Iifting gear position (H1) does not need tobe changed when
mowing or turning (see next page).
"Mowing" position
=
gap of 1 cm between stop-lock suport and stop.
Using the tractor's
Iifting gear, raise or
lowerthe implement
(H 1) until a gap of
about 1 cm is
achieved.
Mowing
Fauch er
5. Cloes front protection covers (5a)
Werbung
Inhaltsverzeichnis
