Balluff BNI CIP-351-000-K015 Betriebsanleitung Seite 325

BNI CIP-351-000-K015
Safe I/O Module, EtherNet/IP™ CIP Safety™
IP67 Module
8. SNCT displays the following information:
Module Identification provides information on the module, you will be able there to retrieved S/N
•
of the module and module MAC address. Software Version displayed in this area provides a
product version, more detailed version of the different elements that compose the module could
be found in "Action\Additional Tools\Information..." (See Additional Information section)
Major/Minor Fault:
•
- No fault: No problem has been detected.
- Recoverable Fault: A fault has been detected like but not limited to:
Additional information on the problem could be found in
correct the problem then restart the module to remove the fault.
Not Recoverable Fault: A hardware major problem has been detected. You should not use any
more the module, contact Balluff technical support team.
• State: This value helps to known the state of the module and define the operations to do:
- Waiting for TUNID: No TUNID is set in the module; Set one before to be able to do any
other operation.
- Configuring: Module have a TUNID but no configuration, download a configuration.
- Idle (Configured): Module is configured and ready to execute but there is no EtherNet/IP
scanner connected.
- Executing: Module is configured and a EtherNet/IP scanner is connected.
- Abort: Module has been triggered in safety state (see Major/Minor Fault below).
• IP/SNN: This is the current TUNID affected to the module.
Lock State: Indicate if the module has been locked meaning that the module is considered as
•
configured and tested.
"Output owner": Indicate if an EtherNet/IP scanner owns the safety output assembly of the
•
module.
The first EtherNet/IP scanner that connects the output assembly will own it and only this
EtherNet/IP scanner will be later authorized to connect this output assembly.
If you would like to allow another EtherNet/IP scanner to connect the output assembly, it is
necessary to perform a safety reset and reconfigure the module.
This list show the two assembly formats:
20 04 25 33 02: Assembly 0x0233 - Safety Discrete Output Profile
20 04 25 01 03: Assembly 0x0301 - Vendor Specific
9. Go Offline and Exit SNCT
www.balluff.com
Rotary switch position modified,
o
Memory key removed,
o
Safety problems on one input or output (short circuit...).
o
Additional Information. You need
149