Installation And Adjustment; Swapping The Battery; Assembly Or Dismantling; Unpacking - Vermeiren Eagle 620 Gebrauchsanweisung

3

Installation and adjustment

The instructions in this chapter are for the specialist dealer.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
WARNING: Risk of unsafe limitations - Use only the limitations described in this

manual.
3.1

Swapping the battery

We shall decline all liability for damage caused by the use of improper battery.
•
Do not use the battery at temperatures below +5° C o r above +50° C (the ideal is
•
+20° C).
If the battery is opened, all liability of the manufacturer shall be voided as well as any
•
claim.
The battery of the patient hoist Eagle 625 can be swapped by an integrated clip system.
3.2

Assembly or dismantling

3.2.1 Unpacking

WARNING: Risk of injury - After unpacking and before further assembly, always

first confirm that the emergency stop (the red pushbutton on the control box) is
pressed in.
The patient hoist packaging has been selected to provide the best possible protection during
transport.
To swap the battery pull on the integrated clip
system. The plate will be lifted and the battery
can take off the holder (control box).
1. Take the patient hoist out of the box and check that
all the items have been delivered and that the
individual parts do not have any visible defects. If
there is any damage, please contact your sales
office.
2.
Before assembly, put on the caster brakes to make
sure that the lift cannot be moved unintentionally.
Push the caster brake plate down gently to its end
stop with the front of your foot. To release the brake,
push the brake plate gently back up again with the
front of your foot until the caster is free.
ƒ‰‡
Eagle
2011-09