VHF K5+ Originalbetriebsanleitung Seite 40

EN 40
F . 47 O
IG PENING FOR THE EMERGENCY RELEASE
You can perform an emergency opening as follows:
1. Switch off the machine at the main power
switch. Disconnect the machine from the eletrical
source.
2. Deactivate the safety interlock of the working cham-
ber door, as shown in the figure (
below ):
a. Remove the protective cap from the emer-
gency release opening.
b. Insert the key for the emergency release of
the working chamber door through the open-
ing.
c. Deactivate the safety interlock of the working
chamber door by turning the key counter-
clockwise by 90°
F
IG
Fig. 48 see

Original Operating Instructions: K5+
Version: 12/16/2021
K5+ – Operation: Executing jobs
. 48 U
SING THE KEY FOR THE EMERGENCY RELEASE
Top: Remove the cap
Middle: Insert the key
Bottom: Turn the key
3. Open the working chamber door.
4. Carry out your work in the working chamber.
5. Close the working chamber door.
6. Reactivate the safety interlock of the working cham-
ber door by turning the key for the emergency
release clockwise by 90°.
7. Check if the working chamber door actually is
locked.
8. If you can still open the working chamber door,
repeat the 3 previous steps.
9. Close the opening for the emergency release again
with the protective cap.