Configuring The Device - Dometic BUTTNER MT 5000 iQ Montage- Und Bedienungsanleitung

Installing the device
fig. 1,
Description
page 3
1 Battery monitor display
2 Control cable
3 Temperature sensor
4 Shunt
5 Fuse
6 Starting battery
7 House battery
8 +12 V control signal
9 Accessories
10 Chassis ground
11 Grounding strap
12 Common ground terminal
13 Battery minus terminal
9. Make sure that all fasteners are properly tightened and connections are secure, including the
connections at the fuse.
8.5

Configuring the device

After connecting the shunt and the battery monitor, the following values must be set:
• Battery capacity
• Battery type and absorption voltage
• Automatic output switch-on threshold
• Automatic output switch-off threshold
• Battery control booster/outside temperature sensor activation
• Display backlight
1. To configure the device, press and hold the Menu button (fig. 2, page 4, 1) for 3 seconds.
2. When the Set text is blinking on upper section of the display (fig. 2, page 4, 6), increase the
capacity value using the Home (fig. 2, page 4, 2) or decrease it with the Output (fig. 2,
page 4, 3) button.
10
3 A
For relays or remote switching inverters
Remote switched by + 12 V control signal
For minus cables from all 12 V consumers,
inverter and charging devices
MT 5000iQ
EN