Troubleshooting - Tronic TCA 3 A1 Bedienungsanleitung

Disconnect your connected device from the car charger adapter once
♦
the device has completed charging .
Unplug the car charger adapter from the vehicle power outlet when
♦
you are finished using it .
ATTENTION
Never connect the car charger adapter unless you are charging a
►
device! The car charger adapter also consumes power in standby
mode and therefore must be disconnected from the vehicle socket
after use! Otherwise, the car battery will discharge when the engine
is not running .

Troubleshooting

A connected device does not charge (the operating LED
not light up white).
No connection to the vehicle socket . Check the connection .
♦
Depending on the vehicle type, it is possible that the ignition has to be
♦
switched on first .
The operating LED
The car charger adapter is overloaded and will no longer charge attached
♦
devices . The internal overcurrent protection has been triggered . Discon-
nect all connected devices from the car charger adapter . The white
operating LED
ready for use again .
│
■ 8
_373026_TCA3A1_LB8.indb 8 _373026_TCA3A1_LB8.indb 8
goes out after a device has been connected.
1
lights up immediately and the car charger adapter is
1
GB │ IE
does
1
TCA 3 A1
01.09.2021 14:17:18 01.09.2021 14:17:18