Operation - Bartscher A120880 Bedienungsanleitung

•
Make sure you position the device properly, so the ventilation openings at the back of
the device are not covered or blocked.
•
Do not place the device near a wall or any flammable materials. Leave a space of at
least 20 cm each side.
•
Do not place anything on the device.
•
Remove the protective foil from the appliance. Ensure that it has been completely
removed.
NOTE!
The device is not a built-in device and should not be installed as such!
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.

5.3 Operation

Preparing the device for use
•
Prior to first use, clean the interior and exterior of the device with a soft, moist cloth
and mild cleaning agent.
•
Prior to first use, heat the device without food inside. Set the temperature to the highest
level (250 ° C ), and the timer for 15 min. A small amount of smoke or unplea-sant odor
may be emitted. This is normal during first use and will not happen during future use.
Afterwards, open the door in order to allow the device to fully air out.
•
Clean the grid and baking tray with a mild cleaning agent. Rinse in clean water and
dry with a soft, dry cloth.
- 24 -