EN
Input
24 V
28
Set
CIC
Output
7.2
Start up Infinity AP only
The required backwash interval must be set on
the filter.
The setting is made with the Set key
Key
Press Set for 5 seconds
Display dots flash
Device is in programming mode
Press Set
Press Set
Press Set
Press Set
Pressing the Set key again steps up the number of
h (hours) or d (days).
The hours h run from 1 – 24, followed by days d from
2 – 56, followed by the hours again etc.
Press the Set key until the desired value has been
set. The value is saved 10 seconds after the last in-
put. The display dots fade out. The unit backwashes.
The time until the next backwashing and the pres-
sure difference appear alternately in the display.
The pressure difference is only displayed for large
volumes of water.
The filter is ready for use.
Display
SL 0
SL 1
SL 2
SL 3
1 h