Installation - BWT Infinity M Einbau- Und Bedienungsanleitung

> 400 mm
> 1 m
1.
3.
A
> 20 mm
min. DN 50
2.
4.
6

Installation

Install the filter in the cold water pipes in front of the
objects to be protected (see installation diagram).
Always provide stop valves.
Install connecting module or connector in the direc-
tion of flow in the horizontal or vertical cold water
pipe (observe direction of flow arrow).
Route the flushing water connection to the drain so
that no reflux occurs.
Note: The flushing water hose must be secured at
a distance of at least 20 mm from the highest
possible waste water level (free discharge).
Connection to connecting module
3/4" - 1 1/4"
1. Turn the black retaining ring to the left limit stop.
2. P ress the prongs of the device into the spaces
provided
3. Rotate the device clockwise 45° to the limit stop.
4. P ull the black retaining ring with both hands
towards the device until it clicks into place. The
device cannot now be rotated unintentionally.
T o release the filter, press the retaining ring
towards the connecting module.
Connecting to connector 1 1/2" and 2"
1. S crew the filter to the connector using 4 hexa-
gon screws and the seal (screws and washers
included).
2. C heck the seal for proper fit. The four bars must
be plugged into the filter head and the seal must
lie completely in the two grooves, see figure A.
Tighten the screws evenly and crosswise.
EN
21 21