Interface Information / Wiring Diagrams - Balluff BIS C-60 2 Serie Handbuch

C60_2-028_823024_0401-e.p65
53
Remote bus cable
and interfaces for
PROFIBUS-DP
54
Wiring diagram for
BIS C-6002
processor with
integrated read/write
head
Terminal location and
designation
54 E
BIS C-6002-...-KL2

Interface Information / Wiring Diagrams

To insert BIS C-6002 processor into the serial PROFIBUS, terminals 1and 2 and 5 and 6 for
the PROFIBUS-DP interface are located on the terminal block ("incoming" and "outgoing").
Bus station
green
red
In case the processor is the last bus module in the chain, then only the incoming cable is con-
nected. You can either use the connections 1 and 2 or 5 and 6.
The last bus module must terminate the bus with a resistor. In the case of the BIS C-6002, this
can be realized in two different ways:
1. In the device
by closing the switch S2
(factory standard is open)
2. Outside the device in a plug. In this case the signals VP (terminal 4) and DGND (terminal 3)
should be brought out in order to connect the external resistor to the potential.
Note: In this case S2 has to be open!
BIS C-6002-...-KL2
Interface Information / Wiring Diagrams
1
2
3
4
5
6
7
8
S1
Head 1
Head 2
Terminal
19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 block
S2
Protection
ground PE
PROFIBUS-DP
Supply voltage,
input/output
Bus station BIS C-6002
Terminal
block
red
green
S2 Terminating resistor
closed active
open passive
Terminal block connections
The ground connector should be connected to earth directly
or through a RC combination depending on the system (po-
tential counterpoise).
When connecting the bus leads, make sure that the shield has
proper connection to the PG housing. Please note the assem-
bling instructions on 52.
Bus station
E 53
01 = CT Present 1
02 = CT Present 2