Installation; Power Limiter - Atag BIH064 EV-Serie Bedienungsanleitung

INSTALLATION

Power limiter

Setting the power limiter should only be carried out by a registered and qualified
installer. Please read the safety regulations and the installation instructions
carefully.
The hob is equipped with a power limiter. If the total power of operating cooking zones exceeds
the maximum available amount of power, the power is automatically reduced. The display of the
cooking zone who is being reduced in its power is first flashing; the level is then automatically
reduced to the highest available power.
• For models BIH064 -- EV and BIH074 -- EV:
The limiter is set at 7400 W by the factory, but it is possible to change it to 700 W,
▷
1400 W, 2300 W, 2800 W, 3000 W, 3700 W, 4600 W or 6000 W.
• For models BIH085 -- EV and BIH095 -- EV:
The limiter is set at 7400 W by the factory, but it is possible to change it to 1400 W, 2300
▷
W, 3000 W, 3700 W, 4600 W, 6000 W or 10400 W.
Power limiter configuration
Make sure there are no pots or pans on the hob before you start!
1. Disconnect the appliance from the main power supply by removing the power connector
from the socket, by removing the fuse or turning the circuit breaker off.
2. Reconnect the appliance to the power supply.
The boost key is flashing.
▷
• Perform, within 2 minutes after reconnecting the hob to the power supply, the
following steps.
• Make sure all cooking zones are switched off.
EN 24