Operation Of The Light Source; Brightness Settings And Adjustment; Memory Storage Stages - Zeiss CL 6000 LED Bedienungsanleitung

CL 6000 LED- | CL 9000 LED-Bedienungsanleitung

4 Operation of the light source

4.1

Brightness settings and adjustment

Rotate the encoder (2) in order to adjust the intensity (up: clockwise direction; down: counter-clockwise direction).
By repeatedly briefl y pressing the rotary encoder (2) the intensity can be adjusted in pre-set stages of 0, 20, 40, 60, 80 and 100
(factory pre-settings).
A menu can be accessed by pressing the incremental encoder (2) for at least 3 seconds. The menu navigation is shown in the
LCD display (3). In the menu, individual intensities in 6 memory locations can be set and stored.
In addition, fi ne setting of the rotary encoder can be determined by the user, to be chosen from the following settings: coarse (25
steps), medium (50 steps) and fi ne (100 steps).
The factory settings of the device can be re-instated.
The menu functionality is explained in detail in Chapter 4.3 „Setup menu and LCD display".
Display indication directly after switch-on.
The display changes after a few seconds.
CARL ZEISS
CL 6000 LED
(Also applicable to CL 9000 LED)
Intensity set to Zero.
Rotate the incremental encoder (2) to change the in-
CL 6000 LED
Light: 0
tensity e.g. to 33. (Also applicable to CL 9000 LED
Intensity has been set to 33t.
Rotate the incremental encoder (2) to change the inten
CL 6000 LED
Light: 33
4.2

Memory storage stages

By repeatedly briefl y pressing the rotary encoder (2), successively stored brightness levels which were saved in the device's 6 me-
mory slots can be accessed. The factory settings are 0/ 20/ 40/ 60/ 80 and 100. The memory slots can be programmed individually
in the setup menu. Each of the 6 memory slots can be assigned brightness values from 0 to 100 or can be completely switched
off so that the respective storage slot will not be accessed when the rotary encoder (2) is pressed.
Example:
To quickly switch between the maximum brightness level 100, dimmed brightness level at stage 25 and „light off/no brightness",
the 6 memory slots can be programmed as follows:
Mem 1 -> 100
Mem 2 -> 25
Mem 3 -> 0
Mem 4 -> OFF
Mem 5 -> OFF
Mem 6 -> OFF
By repeatedly briefl y pressing the rotary encoder (2), the following sequence is activated:
100 -> 25 -> 0 ->100 -> 25 -> 0 ->100 -> 25 -> 0 ->100 -> 25 -> 0 ->...
The functionality of the menu is described in detail in Chapter 4.3 „Setup menu and LCD display".
28 Stand Oktober 2015