Special Functions - Lupine WILMA R Bedienungsanleitung

Special Functions

Additional beams for special applications:
Changing the factory-set SOS function
It is possible to change the factory-set SOS signal to
different brightness levels, or to special-purpose RVLR or
Alpine Emergency signals.
1.
Press and hold the button
until 2 green LEDs light up.
release the button

2.
The range of brightness levels you can select will
automatically begin to cycle, as shown.
3.
Press the button when the brightness level you
want is presented.
Depressing the button for 3 seconds will initiate
the flash mode selected, and the lamp will
continue flashing in that mode until the battery
is completely discharged.
3 6
0.3 W
brightness level
1.5 W
brightness level
3 W
brightness level
5 W
brightness level
7 W
brightness level
10 W
brightness level
14 W
brightness level
19 W
brightness level
23 W
brightness level
28 W
brightness level
SOS*
RVLR*
Alpine SOS*
Flash*
Default setting
* Will not be signalised by status LED
Alternative Capacity Indicator (lamphead):
1.
Before activating the alternative capacity indicator,
your battery must be fully charged.
2.
Press and hold the button
until 3 green LEDs light up.
release the button

3.
The range of battery capacities you can choose
from will start automatically.
You must approximate the correct range for your
battery; e.g., for an 13.8Ah you would select 14Ah
(5 blue LEDs)
Similair to our Smartcore batteries the red LEDs

on the lamphead will now approximatley show the
remaining capacity.
Attention! When the lamp-head is disconnected
from a battery, the status information is lost. You
need to fully recharge the battery to make it work
again.
2 Ah
3 Ah
4 Ah
5 Ah
6 Ah
7 Ah
8 Ah
9 Ah
10 Ah
12 Ah
14 Ah
16 Ah
18 Ah
20 Ah
Disable
indicator
37