Additional Functions - Lupine NEO Bedienungsanleitung

Additional functions:

Voltage test:
After connecting the lamphead to the battery, the upper and lower red LEDs will blink to
indicate the battery voltage. The voltage helps to interpret the remaining capacity.
Upper red LEDs blinks: 1 time each volt
Lower red LEDs blinks: 1 time each 1/10 volt
Hints:
More than 8V = battery fully charged
7.1 to 7.9V = recharge
Below 7V = not or only partly ready for use
Low battery warning:
Once the remaining capacity dropped by a relevant amount, the lampheads red LEDs will
turn on. If the battery is empty, the lamphead itself will start to flash a couple of times.
Stop immediately! The light will switch off by itself.
Reservepower:
After switching the light on again, reserve power is available for a short while.
Slow down since the light will be switched off automatically.
Important: charge the battery in a short while. Deep discharging will harm the battery.
An activated reservepower will be shown by the red LEDs flashing.
For example:
7x upper red LEDs
+
3x lower red LEDs
=
7.3V
www.lupine.de