Product Care And Storage - Lupine WILMA R Bedienungsanleitung

Operation
Capacity Indicator:
Audible:
To check the capacity, simply press
the touch-pad once. At first an audible
signal will sound to give a quick reading
in 20% steps.
Visible:
The visible indicator uses 5 red LEDs. The LEDs can operate in two different
operating states: blinking and continuous. LED meanings: A blinking LED
is indicating a 10% step and a continuously glowing LED a 20% step.
Example: 3 LEDs steady glow (20 %, 40 %, 60 %)
1 LED blinking (80 %)
= 70 % remaining capacity
Taillight
To run the taillight simply press the touch pad two times and the 5 LEDs will
operate continuously. To switch off the taillight, simply press the pad again.
Moving light:
Press the touch pad three times to activate the moving light. To switch it off
press the button another time.
Note: The capacity indicator will fade out within a few seconds. If it does not,
eventually the taillight was activated and the 5 glowing LEDs do by far not
mean the battery is fully charged.
2 6
5 x = 100 %
4 x = 80%
3 x = 60%
2 x = 40%
1 x = 20%

Product care and storage

Transport:
Important: Always keep the battery separate from the Wilma light, because otherwise the small amount of
power used by the electronics will discharge the battery, and the lamp may switch on
accidently. Important! Moreover, the consequent uncontrolled heat buildup could cause a fire or melt the
adjacent plastic material. Could cause fire or death!
Storage:
During lengthy periods of non-use, fully charge the battery and store it in a cool, dry place, basement or
the like. The battery can be kept plugged into the charger if desired.
Opening the frontcap:
Open the light housing's front screw-on cover. Grasp the rear section of the lamp with one hand while
rotating the front section of the cover to the left (counterclockwise) with the other hand. Once you have
removed the cover, you will see the 4-array lens. Do not touch it.
Closing the frontcap:
Check to ensure that the O-ring on the rear section of the housing is correctly positioned.
The housing will only be waterproof if its O-ring is intact. After completing this inspection, carefully screw
down the housing cover. Important note: if the thread runs smooth, the cap is in the right
position. Otherwise please stop and screw back the cover and try again, otherwise you might
damage the thread.
Bluetooth module:
The housing of the Bluetooth module on the underside of the lamp head may only be opened by Lupine or
authorized distributors.
2 7