Clamping The Workpiece; Adjusting The Cutting Angle; Cleaning, Maintenance, Storage, Disposal; Cleaning - HOLZMANN-MASCHINEN BS370TOP Betriebsanleitung

16.4.1 Clamping the workpiece

16.5 Adjusting the cutting angle

17

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

17.1 Cleaning

Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Therefore, clean the device after each use of chips and dirt particles.
HOLZMANN MASCHINEN GmbH
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
 Open the vice with the hand wheel (17)
 Insert workpiece so that it rests against the fixed
 Insert workpiece correctly (see figure on the right)
 Protruding workpieces must be supported!
 Move the movable jaws to the workpiece by turning
 Clamp the workpiece with the quick lock lever (18).
The cutting angle between vice and saw band can be
adjusted within the specified angle range (see
technical Data).
NOTICE:
angle cutting into account (see technical data)!
Swivelling the saw arm
Procedure:
N O T I C E
www.holzmann-maschinen.at
jaw.
the hand wheel (17) and leave a gap of approx. 3-4
mm.
After completing the cutting process, the quick
o
release lever (18) is released and the
workpiece can be removed.
When the quick-release lever (18) is released,
o
the movable jaw opens. The originally
determined distance to the workpiece
remains.
This facilitates rapid re-clamping of
o
workpieces of the same length.
 The saw arm can be swivelled to the right at an
angle of up to 60°.
 This requires a positioning of the vice to the left.
 Procedure: see 16.4
 If the saw arm is positioned on the left side, it is
possible to cut at an angle of up to 45°.
 This requires a positioning of the vice to the
right.
 Procedure: see 16.4
Take the lower cutting performance for
 Turn the saw arm lock lever (19) to the left. Saw
arm can be swivelled.
 Use the handle (20) to turn the saw arm until
you reach the mechanical stop.
 Check if the desired angle corresponds to the
indication on the scale (21).
 Turn the saw arm lock lever (19) to the right.
39
BS370TOP