Dispensing ice cubes
To dispense ice cubes, use a vessel with an
opening of at least 7 cm, which will prevent
ice from falling.
When you switch the appliance set-
tings from crushed ice dispensing to
'Dispensing ice cubes', residual
crushed ice will be initially dispensed
from the ice outlet.
QUICK FRZ
QUICK REF
FILTER RESET /3S
(27)
(25)
1. Press the DISPENSER selection but-
ton (25) enough times until the
bol (27) appears on the display.
2. Hold the vessel as closely as possible to
the opening for the ice (36), in order to
avoid ice cubes from falling out around
the sides of the vessel.
3. Push the vessel against the dispenser
guide (35). Ice cubes will begin to pour
into the vessel.
4. Remove the vessel from the dispenser
guide to stop the flow of ice cubes.
Removing cold water and ice
Locking/unlocking the ice maker
Locking
If you plan not to use the cold water and ice
dispensing functions for an extended period
of time, you can lock the ice maker:
MODE
1. If applicable, unlock the control panel by
pressing the LOCK/UNLOCK button (22).
2. Press the ICE OFF button (30). The
symbol (28) lights up on the display.
sym-
(36)
3. Lock the ice dispenser (2) using the lock-
(35)
ing box (34) to conserve energy.
Unlocking
1. Remove the locking box (34) and close
the door to the freezer.
2. Unlock the control panel by pressing the
LOCK/UNLOCK button (22).
3. Press the ICE OFF button (30).
Page EN-27
QUICK FRZ
QUICK REF
FILTER RESET /3S
(30)
(28)
(34)
(2)