Homelite HCS3335 Bedienungsanleitung Seite 44

GB
F D E I
PROBLEM
Engine starts and runs,
but chain is not rotating.
Bar and chain running hot
and smoking.
NOTE: The carburettor adjustment needle(s) are equipped with plastic cap(s) which prevent anticlockwise
rotation from the original factory adjustment. If your product exhibits specific performance problem(s) where the
Troubleshooting Section recommends an anticlockwise needle adjustment and you have made no adjustments since
the original purchase, take the product to a factory authorised service dealer for repair. In most cases, the needed
adjustment is a simple task for the factory trained service representative.
P NL S DK N FIN GR HU
TROUBLESHOOTING
POSSIBLE CAUSE
1. Chain Lubricant tank empty.
2. Check chain tension for
overtight condition.
3. Check for Lubricating function.
1. Chain brake engaged.
2. Chain tension too tight.
3. Check guide bar and
chain assembly
4. Check guide bar and
chain for damage.
CZ RU RO PL SLO HR TR EST LT
English
SOLUTION
1. Lubricant tank should be filled every time
that fuel tank is filled.
2. Tension chain per instructions in
"Maintenance – Adjusting the Chain
Tension" earlier in this manual.
3. Run at half throttle 30 to 45 seconds.
Stop saw and check for Lubricant dripping from
guide bar. If Lubricant is present the chain may
be dull or bar may be damaged. If no Lubricant
is on the guide bar, contact a Homelite service
dealer.
1. Release chain brake, refer to
"Operation – Operating Chain Brake"
earlier in this manual.
2. Tension chain per instructions in
"Maintenance – Adjusting the Chain
Tension" earlier in this manual.
3. Refer to "Maintenance – Assembling the Bar
and Chain" earlier in this manual.
4. Inspect guide bar and chain for damage.
36
LV SK BG