SICK SureSense HSE18L Bedienungsanleitung Seite 3

2
CORRECT USE
3 Commissioning
2
Image: A
1 Observe the application conditions: Adjust the distance between the sender and
the receiver according to the corresponding diagram [H] (x = sensing range, y =
operating reserve).
If several through-beam photoelectric sensors which are installed next to one ano‐
ther are to be used, we recommend swapping the sender / receiver arrangement
at every second through-beam photoelectric sensor and ensuring that there is suf‐
ficient distance between the through-beam photoelectric sensors. By doing this,
mutual interference can be prevented [cf. F].
Operating reserve
10,000
1,000
100
10
1
0 10 20 30 40
(32.81) (65.62) (65.62) (131.23) (164.04)
Distance in m (feet)
Image: H
2 Mount sensors (sender and receiver) using suitable mounting brackets (see the
SICK range of accessories). Align the sender and receiver with each other.
Note the sensor's maximum permissible tightening torque of 0.56 Nm.
3 The sensors must be connected in a voltage-free state (U
in the graphics [B] must be observed, depending on the connection type:
– Male connector connection: pin assignment
– Cable: core color
50 60
(196.85)
= 0 V). The information
v
8017857.YMH6 | SICK Subject
to change without notice