Setting/Replacing Paper Rolls; Self-Printing - Citizen CT-S281 Kurzanleitung

5 Setting/Replacing Paper Rolls

1. Press the cover open button down.
2. Open the printer cover.
3. Insert a paper roll with is print area facing
down as shown in the figure and pull out
the paper end straight forward by several
cm out of the printer.
4. Close the printer cover until a click can be
heard.
WARNING
● When opening the printer cover, take care not to touch the print head or cutter blade.
Otherwise, burning or injury of hand may result.
CAUTION!
● Always use the specified types of paper roll.
● Confirm that the paper roll is set correctly.
● When the paper is skewed and not extended straightforward from under the cover,
open the cover and adjust the paper correctly.
● When closing the cover, press on the both front sides marked or the center of the cover
to close it firmly.
● When setting paper, pay attention not to let your fingers get injured by the edge of
paper.
● When setting a label paper roll to the printer, be sure that there is no uneven portion
on the roll paper side. If the roll paper side is uneven, set it evenly.

6 Self-printing

Insert paper into the printer. With the FEED button pressed and held, turn the printer
power on, keep the FEED button held for about 1 second, and then release the FEED
button. The printer starts self-printing. The printer prints model name, version, DIP
switch setting, memory switch setting, and built-in fonts.
Cover open button
Firmware version
Interface
Serial communication
condition (Only serial
interface model)
Buffer size
DIP switch setting
(Only serial interface
model)
— 7 —
Memory
switch
setting