4.4 Setting/Replacing Paper Roll
1
Cut the top end of the paper roll at about right angle to the roll direction.
2
Insert a paper roller into the paper roll.
3
Check the winding direction of paper roll and set the paper roll to the paper holder.
4
Confirm that the printer power is on.
5
When any paper remainder is present after paper low alarm, remove the paper roll in
accordance with "4.5 Removing the Remaing Paper Roll".
6
Lift the head up lever of the printer mechanism.
7
Insert the top end of the paper roll into the paper slot straightforward until it reaches a
stop.
8
Press down the head up lever. The paper is automatically pulled into the platen roller
(see "4.11 Auto Loading") and then cut. When the ejected paper is removed, the
printer is now ready for printing.
CAUTION
• Always use the specified type of paper roll.
• Use of other type of paper roll may result in a failure in assuring the print quality, head life,
presenter function, etc.
• Paper roll with fluffed or folded end shall not be inserted. Paper jam or wrong insertion of
paper may occur.
• Rewind the paper roll to remove loose winding.
• When the paper roll is set slanted, lift the head up lever and adjust the paper roll position or
remove the paper roll and then place it correctly.
• Do not lift or hold the paper roll during printing. Otherwise, paper jam may occur.
• After paper setting is completed, the printer is ready for printing. In this case, note that
printing occurs just after paper setting if data remains in the buffer.
Paper Roller
Head up Lever
— 21 —