Partition For Paper Roll; Setting Dip Switch - Citizen CT-S2000 Benutzerhandbuch

3.5 Partition for Paper Roll

At the time of shipment, this partition is set to "80-mm
wide roll paper position".
1. Confirm that the power switch is OFF.
2. Open the printer cover.
3. Set the partition to each to the slot which
meets the width of the paper roll used. When
using the 83-mm wide paper roll, remove the
partition.
4. Change the setting of paper width by reffering
to the section 5.2, "Manual Setting of Memory
Switch".
CAUTION!
When setting the partition to the slot for 58 mm or 60 mm paper roll, be sure not to set
it slanted.

3.6 Setting DIP Switch

The DIP switch is present on the serial interface
board.
Remove the board fixing screws, take out the
interface board, and then set the DIP switch. The
function of each switch is as shown below.
CAUTION!
When setting the DIP switch, DO NOT remove screws other than those for mounting
the serial interface board.
Switch No. Function
1 Communication condition DIP switch setting
setting method
2 Hand shake
3 Bit length
4 Parity check
5 Parity selection
6
Baud rate selection
7
8 INIT
Selecting baud rate
Baud Rate (bps)
2400
4800
9600
19200
1200, 38400, 57600 and 115200 bps can also be selected by a command, etc.
Interface board
mounting screws
ON
XON/XOFF
7 bits
With parity
Even parity
See Table below.
Reset
Switch No.
6
OFF
ON
OFF
ON
— 15 —
60mm
80 58mm
mm
DIP switch
InitialSettings
OFF
Memory switch
setting
DTR/DSR
8 bits
None
Odd parity
Invalid
7
OFF
OFF
ON
ON
Partition
OFF
OFF
OFF
OFF
OFF
ON
ON
OFF