Abus PR2600 Montage- Und Bedienungsanleitung Seite 39

2. Lock door bars and remove the door cylinder in the specified order according to Fig. 5.
3. Change the grub screw and the gear-wheels clip of the standard door cylinder to the new
door cylinder, according to Fig. 5. The grub screw must protrude at the same distance on
both sides.
If the cylinder length does not change, continue to point 8.
4. Unscrew the loosened screw 1 (Fig. 6), move the gear-wheel housing in the direction of
the arrow. Unscrew the cylinder protection's screws located beneath (Fig. 6).
5. Remove the cylinder protection according to Fig. 7 and place additional spacer disc/s
(Tab. 1.) between the cylinder protection and the lock body. Tighten with screws (Tab. 1).
6. Pull the gear-wheel housing into the old fitting position again (Fig. 6) and fix loosely
with screw 1.
7. Push toothed gear racks in the direction of the arrow (fig. 8) until they stop, whereby
the upper ones must be pushed back by one tooth.
Fig. 5
5.
3.
Abb. 7
8. Reinstall the door cylinder in the reverse order (Fig. 5). If the indentations do not
correspond, loosen the stop screws 6. and 7. (Fig. 8), pull both door bars out until
the gear-wheels do correspond and complete the installation of the door cylinder.
Set the key pull-off position (see the instructions below).
6.
4.
2.
Fig. 6
3.
3.
2.
GB
1.
39