Set Volume; Setting Volume; Language; Setting Language - Motorola MTP850 S Ausführliche Bedienungsanleitung

Note: Upon entry into this sub-menu, the display shows the current ring style used.
4 Scroll to the desired style and press Select.
Note: New ring style is played immediately for a few seconds. If necessary, adjust the volume level.

Set Volume

This menu item allows you to adjust the Simplex, Duplex, Earpiece, Speaker, and Keypad tone volume.

Setting Volume

Procedure:
1 From the home screen, press the
2 Select Setup → Set Volume.
3 Select one of the following:
• Duplex Vol — sets the volume level for duplex ringtones.
• Simplex Vol — sets the volume level for simplex ringtones.
• Earpiece Vol — sets the volume level for the earpiece.
• Speaker Vol — sets the volume level for the speaker.
• Keypad Vol — sets the volume level for keypad tones.
Note: If the display shows only one option Volume, you can adjust all of the above settings at once.
You have the option to change the settings individually when the Volume Adj. Mode is set to
Individual.
4 Press right or left N
Note: When the battery level is low it is not recommended to attach the 4 Ohm speaker to the radio as it
can cause reset or shutdown of the radio.

Language

This sub-menu allows you to change the language of the radio.

Setting Language

Procedure:
1 From the home screen, press the
2 Select Setup → Language.
3 Select desired language.

Data Setup

This menu item allows you to set up your radio to transmit and receive data from the external device.
To connect your radio accessory connector to the external device, use the PMKN4025 cable. The external device
must run an application complying with the TETRA standards.
Note:
• Data services are available only in TMO Mode.
• Data services are blocked in TXI Mode.
• When set to Voice Only, the built in data modem is disabled to conserve battery power.
key.
MENU
key to change the value.
AVIGATION
key.
MENU
Main Menu | 79
| | Send Feedback