Replacing The Lamp; Closing The Door; Technical Data; Installation - AEG Electrolux S60290KG1 Benutzerinformation

30

Technical data

Replacing the lamp

1. Disconnect the appliance.
2. Push the movable part to unhook the
lamp cover (1).
3. Remove the lamp cover (2).
4. Replace the lamp with one of the same
power and specifically designed for do-
mestic appliances only.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the ap-
pliance before installing the appliance.

Positioning

Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
All manuals and user guides at all-guides.com
Height
Width
Depth
1
S60290KG1
1540 mm
595 mm
648 mm
20 h
2
S60346KG
1750 mm
595 mm
648 mm
20 h