SPORTSTECH HTX500 Benutzerhandbuch Seite 29

Step 10:
Figure 14
Then place the jumping mat (#C) in the middle of the basic structure and lay
it down with the protective net (#D1) above. Make sure that the protective
net Velcro fastenings point inwards towards the center of the trampoline
and those on the lower edge openings are positioned parallel to the metal
hooks of the jumping net. Laying out the jumping mat and the protective
net, start with the 48/54 metal hooks from below as well as from the inside
to the outside through the openings above in the protective net and hang
the metal springs (#D2) with the closed end in the direction of the jumping
mat (Fig.14).
Step 11:
Figure 16
Before you take the next step, make sure that the one Figure 15
with the yellow zipper is on The marked entrance and
exit is located to the right of one of the six protective
net holders. Start now by inserting the spring located
on the left below the entrance and exit into the opening
provided on the basic frame (Fig.15).
Then walk around the trampoline in a clockwise
direction and first hook in four more springs at a
distance of 9 eyelets (including the first spring) in a
similar way (Fig. 16). On the 8 ft trampoline, take every
EN
7th eyelet. To complete the circle, a sixth spring should
be clamped in the tenth loop after the previous spring.
Note: Always make sure that the springs engage
properly on the steel frame. You should hear a clear
click.
Figure 17
Step 12:
Now hook the remaining springs clockwise to the
basic structure, so that the result looks like Figure
17.
Note: If inserting the springs by hand proves to
be too difficult, use the tension hook supplied (Fig.
18) and, if necessary, pull on the respective metal
spring using your body weight (Fig. 19).
Figure 18 Figure 19
Please only allow adults to perform this step - and
with extreme caution - to prevent slipping and injury.
29