SPORTSTECH HTX500 Benutzerhandbuch Seite 28

Step 7:
Now connect this protective net holder to the basic
structure so that the long end follows at the top
and is curved towards the center of the trampoline.
Figure 10
To fix it, use two screws (M6 * 7) from the outside
through the openings provided at the lower end of
the protective net holder and equip them with one
on the other side of the pipe rubber nut (fig.10).
Now place this on the outside of the respective
stand (#A1), guide the screws through the openings
provided for this purpose (Fig.10) and secure on
the other side with a nut each using a washer and
tighten in a clockwise direction.
Figure 11
Repeat this step a total of six times.
Step 8:
To increase your security, bring one of the black
protective caps in a further step on the long screws
that have just been fixed by turning them clockwise
to tighten (Fig.12).
Figure 12
Step 9:
Once all of the protective net holders have been
attached, pull them over the black protective covers
(#B5) from above (Fig. 13).
Note: The side with the slightly closed opening
should be facing up.
Figure 13
28