Technical Specifications - ADURO P4 Bedienungsanleitung

•
Do not use liquid fuels.
•
Use only original spare parts provided by Aduro A/S.
•
Avoid any improper transfers or knocks that may damage the structure or the components.
•
The metal structure is coated using high temperature paints. When using the stove for the first few
times, unpleasant odours may be given off due to the paint of the metal parts that is drying: this is in
no way dangerous and if it happens, simply ventilate the premises. After the first heating cycles, the
paint will reach its maximum adhesion and all its chemical and physical features.
•
To reload the pellet container, simply open the access lid and pour in the pellets. This can also be
done during normal operation. Make sure not to come into contact with hot parts.
•
Whenever the pellet container and the auger become completely empty, the stove will be
automatically switched off. Upon the next ignition, you must load pellets onto the auger (see 7.6).
•
ATTENTION! If the stove is not installed properly, power outages may result in fume
spillages. Under specific circumstances, an uninterrupted power supply unit must be
installed.
Aduro A/S declines all responsibility for any damage which may be caused, directly or indirectly, to persons,
animals, or objects as due to non-compliance with any provision specified in the manual, especially warnings
regarding installation, use, and maintenance of the stove.
The responsibility for improper use of the product is entirely borne by the user and relieves the manufacturer
from any civil and criminal liability. Tampering or unauthorized replacement with non-original spare parts
could be hazardous for the operator's safety and relieves the company from any civil and criminal liability.
Power
Dimension (HxWxD)
Weight
Fuel (dimension)
Exhaust / Inlet
Draft
Pellet container capacity
Voltage
Frequency
Electrical power during the operation
Electrical power during the initialization
Maximal efficiency
Nominal use of pellet
Minimal use of pellet
CO emission reduced on 13%
Maximal exhaust gas temperature
Dust content
Mass flow
Operating temperature
Storage temperature
Max. relative humidity (with no condensation)
Flamme verte class

2. Technical specifications

2,4 kW 8 kW
113 x 56 x 56 cm
117 kg
Wood pellets (Ø6 mm L30 mm)
Ø80 / Ø50 mm
12±2 PA
15 kg
230V ± 15%
50 Hz
55 – 160W *
400 – 460W **
>92% >90%
1,4 kg 2,0 kg
0,7 kg
0,0174% 0,0084%
61 °C 118°C
<20 mg/m3 <15 mg/m3
3,4 g/s 5,9 g/s
5 - 60°C
10 - 65°C
95%

50