Assembling The Threaded Rods; Assembling The Roof Gable; Assembling The Sauna Roof Elements; Installing The Outer Roof - Sentiotec COUNTRY Montageanleitung

Assembly instructions

3.5. Assembling the threaded rods

Connect the threaded rods with each other as shown in the picture and push them
down into the holes provided for them in the block planks.
Screw the flange on the top and fasten the washers and nuts on the bottom.

3.6. Assembling the roof gable

Put on the roof gable and screw it tight.
Note the element with the holes for wiring.

3.7. Assembling the sauna roof elements

Install the roof support slats.
Put in the roof elements.
Carry out the electrical installation - pull in the cables!
If the roof elements are screwed together from above, it will not be possible
to access the roof space later. An inspection opening for the equipment
may then have to be cut in the roof gable.

3.8. Installing the outer roof

Place the rafters in the recesses as illustrated and screw them to the block planks.
Attach the tongue-and-groove boards to the rafters - start at the back.
Gently knock the boards together and nail them to the rafters.
Make sure the boards are consistently parallel.
The roof boards must be flush with the rafters at the front and back - shorten
the boards if necessary.
Assemble the roof edge boards and gable trims.

3.9. Covering the roof

Start laying the roofing felt as illustrated on the lower side of the roof
(20 mm overhang).
p. 9/10
EN