A DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR connector with a
120Ω resistor between the pin 2 and pin 3 of the XLR connector
In DMX mode or Master/slave mode, the maximum device linked are 32pcs
PANEL CONTROL DESCRIPTION
Please use the control panel to setup the moving head (DMX address, operating mode,.... )
MENU BUTTON
Used to access the menu or return to a previous menu option
You can choose between 7 menu options:
→ AU01: Auto mode, The moving head plays the built-in programs,
Use Up and Down buttons to select one of the 2 built-in programs AU01 (fast ) or AU02 (slow), then press Enter
button to validate functions
→ SNOF: Sound control mode, use Up and Down buttons to select SNON (Sound control on) to activate sound
control mode. Select SNOF to disable sound control mode.
→ RPOF (Normal Pan) or RPON (Reverse Pan), Use Up and Down buttons to select Pan control mode and press
Enter button to validate
→ RTOF (Normal Tilt) or RTON (Reverse tilt), Use Up and Down buttons to select Tilt control mode and press Enter
button to validate
→ RDOF (Normal display) or RDON (Reverse display), Use Up and Down buttons to select display control mode
and press Enter button to validate
→ RPON (DMX mode), Use Up and Down buttons to select the DMX address of the device A001 to A512 and press
Enter button to validate
→ DFON (reset), This function setup the parameters as the factory parameters. Press Enter button to reset menu.
USER CONFIGURATIONS
Setup Automatic move
Press the MENU until it shows AU01
Use the UP/DOWN buttons to set to AU01 or AU02. Press ENTER to confirm.
Setup Sound-controlled mode
Press the MENU button until it shows SNOF.
Use the UP/DOWN buttons to set to SNOF, press ENTER to confirm.
© Copyright LOTRONIC 2012
All manuals and user guides at all-guides.com
UP & DOWN BUTTONS
Use the <UP> and <DOWN> buttons to browse through the
menu options.
ENTER BUTTON
Used to select and store the current menu or option within a
menu.
LMH400LED-MKII
Page 4