Sentiotec Pro D Montage- Und Gebrauchsanweisungen Seite 37

Installation instructions, for professionals only
Selecting sensor for room temperature regulation with additional output
(only Pro D2i/Pro D3i)
For room temperature regulation using additional output (see "Room tempera-
ture control with the additional output" on page 53) the sensor for the
regulation can be selected with the function selection switch 6.
● The function selection switch 6 is set to the OFF position as standard. The heat-
er sensor (F1 sensor) is used for the regulation.
● If you wish to use the bench sensor (F2/FTS2 sensor), activate two-sensor
operation (see: "Activating two-sensor operation" on page 36) and
place the function selection switch 6 in the ON position.
Remote start operating mode
With the function selection switch 7 the start of sauna/evaporator operation or
user program 1/2 can be selected.
● The function selection switch 7 is set to the OFF position as standard. The start
of sauna/evaporation operation is activated. Terminal "S" starts the sauna
operation and terminal "C" starts the evaporator operation.
● If you wish to activate user program 1/2, place the function selection switch
7 in the ON position. Terminal "S" starts user program 1 and terminal "C"
starts user program 2.
Connection: see "5.12. Remote start" on page 31
Temperature/humidity display (actual/set value)
Using function selection switch 8 you can select whether the actual value (tem-
perature, humidity) is displayed or the set level continues to be displayed after
entering the setting.
● The function selection switch 8 is set to the OFF position as standard. The dis-
play of the actual values is activated.
● If you wish to activate the set values, place the function selection switch 8 in
the ON position.
p. 37/70
EN