bürkert POSITIONER 1067 Bedienungsanleitung Seite 66

All manuals and user guides at all-guides.com
3 INSTALLATION
g) Place the cursor of the path-measuring system into the groove "9" of the spindle "8" of the feed-
back/positional transducer and set this spindle onto the spindel of the actuator. Fasten screw "10".
h) Insert electronic board "2" into the slot of the positioner housing.
i) Inside the housing, connect plug "1" of the path-measuring system to the connector of the electro-
nic board, with respect to the wire colours (blue mark)
j) Cut cable "12" at the desired length and pull it through the cable gland "7" of the external feedback/
positional transducer.
k) Connect cable "12" to the connector of the electronic board:
l) Tighten the cable gland "7".
m) Screw the housing "11" of the external feedback/positional transducer.
Fig. 17 Diagram for the assembly of positioner variant 3 and external feedback/positional
transducer
- : brown
A : white
+ : green
11
10
7
6
5
12
E-14-
POSITIONER 1067
+
9
8
1
2
3
4