Installing Reserve Wire; Using Wire Connectors - Viking MI 632 Gebrauchsanleitung

In corridors, the perimeter wire (1) must be
routed parallel, maintaining an 18 cm
distance, and must be attached to the
ground with a sufficient number of fixing
pins (2).
0478 131 9920 C - EN
All manuals and user guides at all-guides.com
A, B, C – examples of corridors.
Do not route the perimeter wire at
acute angles (less than 90°).

11.11 Installing reserve wire

Reserve wire installed at regular intervals
makes it easier to make any necessary
corrections such as subsequently
changing the position of the docking
station or the routing of the perimeter wire.
In particular, reserve wire should be
installed near difficult passages.
Route perimeter wire (1) as illustrated
between 2 fixing pins spaced approx. 1 m
apart. Attach the reserve wire to the
ground in the centre using a further fixing
pin.

11.12 Using wire connectors

In order to extend the perimeter wire or to
connect loose wire ends, only the gel-filled
wire connectors supplied may be used.
They prevent premature wear
(e.g. corrosion of the wire ends) and
ensure optimal connections.
Make a note of the positions of the wire
connectors on the sketch of the mowing
area. ( 11.2)
113