Important Safety Advice; Electrical Connection; Operation - EWT Homeo 2T Bedienungsanleitung

Homeo 2T Ceramic Fan Heater
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

Important Safety Advice

DO NOT use the heater in the immediate
surroundings of a bath, a shower or a swimming
pool.
DO NOT place the heater directly below a fixed
socket outlet.
The socket-outlet must be accessible at all times
to enable the mains plug to be disconnected as
quickly as possible.
DO NOT COVER or obstruct the air inlet and
outlet openings in any way.
DO NOT operate the heater with the mains lead
overhanging the front outlet grille.
The Heater carries the warning symbol
indicating that it must not be covered.
WARNING: In order to avoid overheating do not
cover the heater.
IMPORTANT: If the mains lead of this appliance
is damaged, it must be replaced by a qualified
person in order to avoid a hazard.
WARNING: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an
external switching device, such as a timer, or
connected to a circuit that is regularly switched
on and off by the utility.
This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of
experience or knowledge if they have been given
supervision or instruction concerning the use of
the appliance in a safe way and understand the
hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall
not be made by children without supervision.
Children of less than 3 years should be kept away
unless continuously supervised.
Children aged from 3 years and less than 8 years
shall only switch on/off the appliance provided
that it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning the
use of the appliance in a safe way and understand
the hazards involved. Children aged from 3
years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user
maintenance.
CAUTION: Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
IMPORTANT: Avoid use of an extension cord
because the extension cord may overheat and
cause risk of fire.
The heater must be on a flat stable surface when
in use.
DO NOT use the heater on deep pile carpets or
the long hair type of rugs, or less than 750mm
(30") away from any overhanging surface. Keep
combustible materials such as drapes and other
furnishings clear from the front, sides and rear of
the heater.
DO NOT use heater to dry your laundry.
The instruction leaflet belongs to the appliance
and must be kept in a safe place. If changing
owners, the leaflet must be surrendered to the
new owner.

Electrical connection

This heater must be used on an alternating current
A.C.~ supply only and the voltage marked on the
heater must correspond to the supply voltage.

Operation

When the unit is plugged in the appliance emits an
audible "beep" and the power indicator light illuminates
(see (L) in Fig. 2 and Table 1). The unit is now in stand
by mode. The power light will remain lit until the heater
is disconnected from the power outlet.
Table 1
- Standby Button
- Mode Button
- Oscillation Button
- Timer Button
- Up Button
- Down Button
Table 2
- Power LED (L)
- ECO Mode
- Fan Symbol
- Timer Symbol
- Frost Protection Symbol
- Temperature Symbol
- Low Heat Symbol
- High Heat Symbol
Pressing the Stand by button see Table 1 and Fig 2 will start
the heater. Pressing the Stand by button again will return
the heater to stand by mode after a 6 second countdown.
Upon turning the heater on for the first time, the unit will be
in Low Heat mode. The room temperature, heating mode,
timer and fan symbols appear on the display as needed (see
Table 2 and Fig. 2). The display brightness will dim after 10
seconds if no control buttons have been pressed.