Herunterladen Inhalt Inhalt Diese Seite drucken

Spypoint TINY-W2S Bedienungsanleitung Seite 9

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

16
SETTINGS
To define the options of the camera. To configure the
system in English, hold the button "" until LANGUAGE
is highlighted. Press OK, select ENGLISH and confirm your
choice with OK. The system will change all the menus in
English by itself.
Time Start /
Allow the user to set the period of operation
Time Stop:
of the camera. The start and stop time are
the hours during the camera is in action and
records pictures or videos. Example: if the
user selects a start time "7:00 am" and a stop
time "11:00 am", the camera will only detect
for that period of time and will stay inactive
for the remaining hours. Press OK and use
"" or "" to adjust the hour.
Press again OK to set the minutes. When the
time is properly set, press OK once more to
go back to other settings. For an activation of
24 hours, the same start and stop time must
be entered (example: 00:00 as start time
and 00:00 as stop time. These hours are
the basic configuration of your camera)
Note: The hours can be recorded over a
12 or 24 hours period. Refer to SETTINGS/
TIME FORMAT (00:00 means midnight)
Transmission:
Enables or disables the wireless transmission
(On/Off)
of images to the Blackbox receiver.
When the transmission is enabled:
• Only pictures are transmitted to the
receiver, not videos.
• The quality of the photos on the receiver
is reduced to maximize transmission:
8MP = 800 x 600 pixels
5MP = 640 x 480 pixels
3MP = 320 x 240 pixels
• When in TIME-LAPSE mode, photos are
sent to the receiver except for the "30s"
setting.
• When the delay setting "10s" is selected,
the time between each detection is
calculated
is completed. For example, if the
transmission takes two seconds, the time
between the two detections is 12 seconds.
Delay:
Select the time interval between two photos
(10s/1m/3m/5m/
or videos.
10m/15m/30m)
Additional setting: it is possible to reduce
the delay between detections to 10 seconds
(instead of 1 minute) by using the following
procedure. Note that the battery life will be
affected.
when
the
transmission
17

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Tiny-w2s

Inhaltsverzeichnis