Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX512 CONTROL
DMX Controller
A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR
connectors for DMX connection.
1
Connect the output of your DMX controller to the DMX input DMX IN of the device with a DMX cable.
2
Connect the DMX output DMX OUT of the device to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3
At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4
If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
XLR connection:
CONNECTION TO THE MAINS
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
Connect the device to the mains. Thus it is switched on. To switch it off, disconnect the power plug. Do not
connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains outlet
which is switchable.
Device 1
Start Address 1
Program
Chase32 Step100
Device 2
Start Address 10
22/32
Device 3
Start Address 19
00132514, Version 1.0
Werbung
Inhaltsverzeichnis
