Dmx-Protocol; Sound Control Mode; Master/Slave Mode - EuroLite LED MAT-192 DMX Bedienungsanleitung

If addressing was successful, the display will show „PASS" after about one second; if addressing was not
successful, then the display will show „FAIL" and the address must be entered again.
Controlling:
After having addressed the LED MAT-192 DMX, you may now start operating it via your lighting controller.
Note:
If there is no data received in DMX Mode, the period in „D.XXX" blinks continually to remind you to connect
the DMX signal.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-Protocol

Channel 1
DMX Value:
000 – 012
013 – 025
026 – 038
039 – 051
052 – 064
065 – 077
078 – 090
091 – 103
104 – 116
117 – 129
130 – 142
143 – 155
156 – 168
169 – 181
182 – 194
195 – 207
208 – 220
221 – 233
234 - 255

SOUND CONTROL MODE

LED Display Operation:
Press the MODE button in order to choose „SUXX" in Sound Control Mode. Select the desired sensitivity
level (0 – 31) via the UP or DOWN buttons, SU00 – SU31.
IR Remote Operation:
Press the SOUND ACTIVE button in order to choose „SUXX" in Sound Control Mode. Select the desired
sensitivity level (0 – 31) via the UP or DOWN buttons, SU00 – SU31.

MASTER/SLAVE MODE

LED Display Operation:
Press the MODE button in order to choose „SLAV" in MASTER/SLAVE Mode.
IR Remote Operation:
Press the SLAVE button in order to choose „SLAV" in MASTER/SLAVE Mode.
In the following modes, the effects of the slave devices correspond to the effects of the master devices:
INTERNAL PROGRAMS, AUTO MODE, SOUND CONTROL MODE
Function:
off
Phrase Building-Program
Program 2
Program 3
Program 4
Program 5
Program 6
Program 7
Program 8
Program 9
Program 10
Program 11
Program 12
Program 13
Program 14
Program 15
Program 16
Program 17
Sound controlled
Channel 2
Speed
no use
Speed
1 - 100
Sensitivity 0-31
23/25
Channel 3
Flash
no use
Flash
0 – 100
(0 – 40 Hz)
00031787.DOC, Version 1.0