Maintenance; Maintenance Schedule; Change Saw Blade - HOLZMANN-MASCHINEN KAP 305JL Bedienungsanleitung

6 MAINTENANCE

Don't clean or do maintenance on the machine while connected to the power supply:
Damages to machine and injuries might occur due to unintended switching on of the
machine!
Therefore: Switch the machine off and disconnect it from the power supply before
any maintenance works or cleaning is carried out!
Malfunctions must be repaired immediately by trained persons.

6.1 Maintenance schedule

Loose or lost screws
Damage of any part
Saw blade condition
Readjust miter and bevel angle, laser;
Sharpen saw blade
Change carbon brush

6.2 Change saw blade

WHEN:
You need to change to a different type of blade for better cutting result.
You replace a worn saw blade by a new one
ATTENTION: Use only saw blades with
 max. diameter Ø of 305mm
 max. thickness of 3mm
 25.4 mm inner diameter
 max. RPM of the saw blade must be at least 6000rpm.
 Blade quality HSS or better
To eliminate the hazard of cutting injury, you should wear safety gloves when touching the
saw blade.
Lock the saw arm in the upright position with the interlock knob (23). Fix with the left hand
the saw blade, loosen the flange screw (spare part 164) and remove the flange (spare part
163).
HOLZMANN Maschinen Austria
Operation Manual KAP 305JL
Checks and activities to be performed
Clean machine
Empty dust bag
Change saw blade
www.holzmann-maschinen.at
A C H T U N G
Prior to every operation
Prior to every operation
Prior to every operation
After every operation
After every operation
When necessary
When worn or defect
When carbon brush is worn ( < 4mm )
MAINTENANCE
monthly
Seite 32