Trial Run - Silvercrest SON 90 A1 Bedienungsanleitung

4. Thread the yarn as per the blue markings (4 - 6) (Fig. 32/33).
Fig. 32
5
4
5. Thread the yarn through the left needle (7) (Fig. 33).
6. Lay the yarn to the rear under the sewing foot a.
Fig. 33

Trial run

When yarn has been threaded for the first time, or after a yarn breakage
it must be rethreaded, proceed as follows:
Lift the sewing foot a.
Hold the ends of the threads between the fingertips of your left hand, slow-
ly turn the handwheel 6 two or three times towards yourself and
then check the threads once again.
Lay the material for a trial run under the sewing foot a and slowly start
to sew.
The material will be automatically fed through.
When the task is complete, continue sewing until an approximately
5cm (2") long length of threads has formed at the end of the material.
Cut through the threads with scissors.
- 14 -