Residual Risks; Operation; Attaching/Replacing Accessories; Switching On And Off - Parkside PGSA 12 A1 Bedienungsanleitung

GB IE
the telescopic shaft. There is
a risk of cut wounds.
e) The tool is designed to trim
hedges. Do not use the
tool to cut branches, hard
wood or other. To avoid da-
maging the equipment.
f) Do not attempt to dislodge
a blocked/trapped blade
before switching the tool
off. There is a risk of injury.
g) Never hold or pick up the
device by the cutting bla-
de. Contact with the cutting
blade can lead to injuries.
h) Do not use any accessories
that are not recommended
by PARKSIDE. This can result
in electric shock or fire.

Residual risks

Even if properly operating and hand-
ling this electric tool, some residual
risks will remain. Due to its construc-
tion and build, this electric tool may
present the following hazards:
a) Cuts
b) Ear damage if working without
ear protection.
c) Eye damage if suitable eye pro-
tection is not worn.
d) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
Warning! During operation,
this electric tool generates an
electromagnetic field which,
under certain circumstances,
may impair the functionality
28
of active or passive medical
implants. To reduce the risk of
serious or lethal injuries, we
recommend that persons with
medical implants consult their
doctor and the manufacturer
of their medical implant befo-
re operating the machine.

Operation

Keep to noise abatement regula-
tions and other by-laws.
Attaching/replacing
accessories
Switch off the device and
remove the rechargeable
battery before attaching or
replacing accessories in order
to avoid hazards and injury.
Attaching accessories
1. Put the grass cutting blade (12) or the
bush cutting blade (10) onto the plug-in
connector (14) on the bottom side of
the device head (1).
2. Press the accessory into the direction of
the device head (1).
It will lock into place audibly.
Removing accessories:
3. Press the release buttons (8) on the
device head (1) and remove the acces-
sories (10/12).

Switching on and off

1. If necessary, remove the blade guard
(9/11) before switching the device on.
2. To start the device, push the switch lock
(3) forwards and press the on/off switch
(5). Then release the switch lock (3).
The equipment runs at top speed.