Herunterladen Inhalt Inhalt Diese Seite drucken

Preparation For Use; Vacuum Cleaner Preparation - eta NAVAGGIO Bedienungsanleitung

Staubsaugerroboter 2 in 1 mit smart-app
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 83
GB

4. PREPARATION FOR USE

Remove all packing material, remove vacuum cleaner and accessories.
Remove any adhesive, stickers, or paper from the vacuum cleaner.

4.1 VACUUM CLEANER PREPARATION

Install the watter tank B with a dust tank and the side brush A9 into the vacuum cleaner.
Also, install the main brush (if removed). When fitting and removing the parts, proceed
as shown on Fig. 2, 3 and 4. Use standard fixing elements and buttons for fitting,
consequently, the fitting and removing procedure is intuitive. First open cover A15 to allow
access to the container/tank.
4.2 CHARGER STATION INSTALLATION
1) First remove charging dock cover (see fig. 5), then fit charging adapter connector E into
port D5. Part of the cable can be coiled in the cable space in the charging dock to avoid
its protruding out to minimise the risk (e.g. cable being caught, stumbling etc.). Lead the
cable in the outlet hole D4 and then out of the device. Close charging dock cover.
2) Place the charging dock on the floor, near the wall. Be sure there is sufficient space at
the sides of the base (minimum 0.5 m) as well as before the base (minimum 1.5 m).
Do not change location of the charging dock! This could prevent the device from
returning back to the dock!
3) Connect the adapter to the mains supply (signal lamp D1 lights on – charging dock
is active; this lamp will be on as long as the charging dock is active).
4) Put the device approx. 0.5 m in front of the dock, switch on the vacuum cleaner and
press Back to Charging Dock button. The device will automatically move and park in the
charging dock.
– If the battery has been discharged, place the device into the charging dock manually.
– After connection to the charging dock, the device will be switched on automatically.
– During charging and connection to the charging dock, the device cannot be switched off.
– The cleaning operation must always be started with the robot vacuum cleaner in
the charging dock.
Remarks
GB - 42

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis