Installing The Door Handle; Cleaning Before Use; Commissioning The Appliance - hanseatic HGS14355ENFW Gebrauchsanleitung

Page EN-24 Start-up

Installing the door handle

(14)
(15)
(2)
(14)
(15)
4. Secure the door handle (2) to the door us-
ing the screws provided (14).
5. Cover the screw heads with the enclosed
decorative plugs (15)

Cleaning before use

In order to remove the odour which is present
in all new appliances, wipe the interior with
diluted vinegar prior to first use. Then wipe it
out with clean water and dry all of the parts
off afterwards.

Commissioning the appliance

WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
Do not operate or continue to oper-
■
ate the appliance if it
shows visible signs of damage, for
–
example, the connection cable is
defective,
starts smoking or there is a smell of
–
burning,
makes unfamiliar noises.
–
In such cases, remove the mains plug
from the socket or unscrew/isolate the
fuse and contact our service depart-
ment (see "Service" on page EN-30).
Do not connect to a timer or a sepa-
■
rate remote-controlled system for dis-
tance monitoring and control.
If the mains plug is no longer acces-
■
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; this in-
cludes fuses, circuit breakers and con-
tactors.
Do not kink or pinch the mains cable
■
or lay it over sharp edges. This can re-
sult in a break in the cable.
When positioning the appliance, en-
■
sure the supply cord is not trapped or
damaged.
Do not put portable multi sockets or
■
mains adapters at the rear of the ap-
pliance.
CAUTION
Fire hazard!
Improper handling of the appliance
can lead to fi re and property damage.
Only connect the appliance to a
■
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.