Omnitronic CDV-500 Bedienungsanleitung Seite 26

Front panel
1. CD / MIX / TT-SELECTOR
Select the operating mode.
2. SPEED-SELECTOR
Changes the rotation speed of the platter between 33/45/78 RPM. Press this button to switch between 33
and 45 RPM. Keep this button pressed for 3 seconds to switch to 78 RPM.
3. EJECT-BUTTON
Push this button to eject the disc. The disc will not eject during playback.
4. LED-INDICATOR
Glows, when the slot is loaded.
5. CD-SLOT
Load the disc slowly, and release it once the CDV-500 starts grabbing the disc. Hold the disc with two fingers
on the edge and avoid touching the inside area.
Rear panel
1. PHONO OUT-SOCKETS
The music signal of these RCA sockets is analog. Connect the output to the respective input of your mixer.
2. CD OUT-SOCKETS
The music signal of these RCA sockets is analog. Connect the output to the respective input of your mixer.
3. DIGITAL OUT-SOCKET
The music signal of this socket is digital. Connect the output to the respective input of a digital amplifier.
4. RELAY-SOCKET
Connect the output to a further CD-player via a 3.5 mm stereo mini cable.
5. REMOTE-SOCKET
Connect the output to a faderstart mixing console via a 3.5 mm stereo mini cable.
6. REMOTE SELECT-SELECTOR
Select the playback type for the faderstart-function.
26/40 10593010_V_1_0.DOC