Receiving Measurements Automatically - Bresser Neomeo Colour Bedienungsanleitung

8. In normal display mode, press the ALERT button briefly
several times to enable the desired temperature
alarm(s). Depending on the selection, the symbols
and/or
9. If the outdoor temperature reaches one of the limit val-
ues, the temperature alarm symbol flashes and a warn-
ing tone sounds.
10. Press any button to stop the temperature alarm.
13 Receiving measurements
automatically
Once the power supply is enabled, the base station will dis-
play the measurement readings for indoors. Readings from
the outdoor sensor will be displayed within 3 minutes after
powering it on.
If no signal is received, proceed as follows:
Press the CH button for about 3 seconds to initate reception
of measurements again.
14 Past 24 hours history data
The base station stores the maximum and minimum temper-
ature and humidity values received from the outdoor sensor
until the next manual reset, but for no longer than 24 hours.
1. In normal display mode, press the MEMORY button to
switch to memory mode. [MEM] appears on the display.
2. Press the MEMORY button several times to also dis-
play the time and date information for the values one
after another.
appear individually or together on the display.
13 / 32