Cleaning And Maintenance - Klarstein Icemeister 2G Bedienungsanleitung

EN
22
The ice tray will automatically move back into position under the evaporator and
start the next cycle.
9. The ice basket full indicator
cube maker will stop the ice-making cycle automatically. Gently remove the ice
from the ice basket with the ice scoop. About 5 seconds later, the ice cube maker
will restart its ice making function automatically.
10. The water reservoir empty indicator
lack of water and the ice-making cycle will stop automatically. At that time, remove
the ice basket and add water to the water reservoir, and then press the ON/OFF
button again to restart the ice-making cycle.
1 1. When you have got your desired amount of ice, stop the ice making cycle by
pressing the ON/OFF button
12. Open the top lid and transfer the ice to a freezer.
13. Allow the ice cube maker to reach room temperature.
14. Suggest replacing the water at least once a week. Please empty the water reservoir
if the ice cube maker is not used for a long time.

CLEANING AND MAINTENANCE

To keep your ice tasting fresh and your ice cube maker looking great, we recommend
cleaning your ice cube maker once per week.
1. Stop the ice-making cycle by pressing the ON/OFF button
cube maker from the wall outlet and allow it to warm up to room temperature.
2. If residual water is found in the ice tray, gently push the ice tray back so that all
water drains into the water reservoir.
3. Move the appliance forward to a position 75 mm away from the working table and
open the drain plug to drain out excess water (see below figures).
75 mm
will light up when the ice basket is full and the ice
will light up when the water reservoir is
and unplug the appliance from the wall outlet.
, unplug the ice
Working table