Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning & Use Guidance; Troubleshooting - Klarstein Coolio Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
CLEANING & USE GUIDANCE
1. Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator
frequently. When cleaning,unplug the unit and remove the ice cubes. Use a diluted
solution of water and vinegar to clean the inside and the outside surface of the
Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids,
gasoline or oil. Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in structure,
clear of obstruction. Do not use mechanical devices or other means to accelerate
the defrosting process, other than those recommended by the manufacturer.
3. Reuse the machine after being idled for a period of time, it may not have enough
water to pump for air retard, and the indicator of "ADD WATER" will keep lighting.
At this time, you just need to press POWER button again, the machine can enter
normal state.
4. To ensure the cleanness of ice, please change water for water reservoir at least
once one day. If do not use for a long time, please drain the water out and clean
it up.
5. If the compressor takes a strike action for shortage water, fully water or interruption
of power supply, it will delay for 3mins to start up after restarted.
6. Always use fresh water before starting ice production either at initial installation or
after a long shut-off period.

TROUBLESHOOTING

1. Please note, if a power failure occurs due to disconnection of the power cord, or
the power button has been pushed off during an ice making cycle, small ice chips
may formed and lodge in the automatic shovel causing it to jam. If this occurs, the
ice chips may be removed by disconnecting the power cord and gently pushing
the shovel to the rear of the cabinet and removing the ice chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel can not remove the
ice to ice basket. If not, please push the ice shovel gently by finger, then press
POWER button to restart.
EN
19

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis