Standby Mode; Setting The Time - Silvercrest SMWC 700 A3 Bedienungs- Und Sicherheitshinweise

Cookware
Heatproof glass
Non-heatproof glass
Heatproof ceramic
Microwave-suitable plastic dishes
Kitchen roll
Metal tray/plate
Aluminium foil and foil containers
m
WARNING! Risk of fire! Never use metallic
objects when you are using the product . Metals
reflect the microwave radiation and this leads to
the generation of sparks . This can cause a fire
and irreparably damage the product!
˜ Before first use
m
WARNING! Risk of fire! Never operate
the product when it is empty.
Remove the packaging material (including
protection foils and transport protectors inside
the cooking chamber 14) . Check if all parts are
complete .
Clean the product and its accessories (see
"Cleaning and care") .
Clean the surface with a dry cloth to remove
water or dust . Attach the program overview
sticker 11 to the door frame (fig . B) .
˜ Positioning the product
m
WARNING! Risk of fire! This product is not
suitable for installation in a kitchen cabinet . In
closed cabinets, the ventilation of the product is
not sufficiently guaranteed . The product could
then be damaged and there is a risk of fire!
32 GB/MT
Place the product on a flat surface that leaves
Microwave
enough space for ventilation:
Yes
A minimum of 10 cm of free space must remain
No
between the product and the adjacent walls . It
Yes
must remain possible to fully open the door 13 .
Yes
A minimum of 20 cm of free space must remain
Yes
above the top surface of the product .
No
˜ Assembly
No
Insert the turntable holder 2 on the turntable
drive (inside the cooking chamber 14) .
Place the roller 2 on the roller surface (inside
the cooking chamber 14) .
Place the turntable 2 on the roller and on
the turntable holder . The turntable must rest
properly on the turntable holder .
Connect the power plug 3 with a socket-outlet .
1:00 and
beep sounds .
˜ Operation
NOTES:
There may be a faint odour the first time the
product is used . Make sure there is sufficient
ventilation in the area .
Each press of the controls is acknowledged by
a beep .
˜ Standby mode
If no control is pressed for a longer time, the
product automatically switches to standby
mode . The current time is shown in the display
4 .
˜ Setting the time
Connect the power plug 3 with a wall socket .
1:00 and
beep sounds .
In standby mode: Press and hold
a few seconds . 12 H is shown in the display
4 (H: "Hour") .
are shown in the display 4 . A
are shown in the display 4 . A
7 for