Adjustment Information - Checchi & Magli PLASTIC-STOP PLUS Bedienungs- Und Wartungsanleitung

Safety advice for the adjustments
Adjustment work must be carried out with the work
vehicle on flat, compact ground, with the tractor en-
Adjusting the hoeing shares
The hoeing shares are used to make furrows in the soil where the edges of the mulch sheet will be laid and which are
adjustable in terms of width, depth, and inclination.
UN41 0238IH
To adjust the hoeing shares, proceed as outlined below.
1) Loosen the screw (A).
2) Place the shares at the distance from the edge of the
mulch sheet (B) shown in the figure.
Adjust the shares as required, in the way described.
- Raise or lower the shares to increase or decrease the
depth of the furrow.
- Alter the angle of the shares to increase or decrease
the width of the furrow.
English language

ADJUSTMENT INFORMATION

gine off, parking brake engaged, and ignition key re-
moved, and adopting all the necessary safety meas-
ures required to work safely.
1÷2 cm
3) Tighten the screw (A).
If the pointer (D) prevents the share lowering as desired,
proceed as described.
1) Loosen the screw (C) and lift the pointer (D) without
turning it.
The pointer must not be turned as it would desyn-
chronise the initial inclination of the share in relation
to the gauge scale (E).
2) Tighten the screw (C).
Repeat the same procedure for the other share.
13
B
Use and maintenance
5
1÷2 cm