Husqvarna 150BT Mark II Bedienungsanweisung Seite 9

5. Hold the product with the left hand and put your foot
on the foot plate.
6. Pull the starter rope handle slowly with the right hand
until resistance occurs.
Note:
Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
7. Pull the starter rope handle quickly with the right
hand until the engine starts or attempts to start,
maximum 6 times. If the engine starts, move the
choke lever gradually to the open position and
continue to step 11. If the engine does not start,
continue to step 9.
8. When the engine attempts to start, move the choke
lever gradually to the open position.
9. Pull the starter rope handle quickly with the right
hand until the engine starts, maximum 6 times.
Note:
repeat the starting instructions from step
1.
10. Let the engine run for 30 seconds.
1456 - 002 - 06.05.2021
If the engine does not start,
11. Put the throttle control at idle speed.
12. Push the throttle trigger to adjust the blower speed.
To use the throttle trigger on page 9 .
Refer to
To start a warm engine
• Use the same starting procedure as
engine on page 8 but do not put the choke control in
the closed choke position.
To use the throttle trigger
• To increase the blower speed during operation, push
the throttle trigger until you get the correct speed.
• To decrease the blower speed during operation,
release the throttle trigger until you get the correct
speed.
To start the engine when the fuel is too
hot
If the product does not start, the fuel can be too hot.
Note:
Always use new fuel and decrease the
operation time during warm weather.
To start a cold
9