Overheating Protection; Replacing The Battery; Transport - Silvercrest SHLF 2000 D2 Bedienungs- Und Sicherheitshinweise

˜ Setting the desired
temperature
NOTES:
The temperature values are displayed in
Celsius (°C).
The target temperature
[ 31 ]
temperature are shown in the display
Select a heating operating mode ( ,
[ 5 ] 24 ] [
) with
Set the desired temperature
[ 9 ] [ 26 ]
and .
As soon as the room temperature
the set target temperature
switches off automatically .
The product automatically switches back on
again as soon as the room temperature
falls below the set target temperature
active heating operation, the control lamp
is lit .
˜ Swivel function
The built-in swivel function allows the product to
swivel to the left and right . The air flow is thereby
evenly distributed in the room .
Turning the swivel function on/off: Press
4 ] [ [ 25 ]
.
When the swivel function is active,
shown in the display
˜ Timer
The timer turns off the product automatically after a
preset time elapses .
Setting the timer: During operation, press
3 ] [ [ 22 ]
.
The hour display starts flashing .
Set the hours with
[ 3 ] 22 ] [
Press to confirm .
The minute display starts flashing .
Set the minutes with
32 ] [
and the room
[ 6 ]
or
.
[ 32 ] [ 7 ] 27 ] [
with
[ 31 ]
reaches
32 ] [
, the product
[ 31 ]
[ 32 ]
. In
[ 11 ]
[ 28 ]
is
[ 6 ]
.
7 ] [ [ 27 ] [ 9 ] [ 26 ]
and
[ 7 ] [ 27 ] [ 9 ] 26 ] [
and
[ 3 ]
Press
5 seconds .
When the timer is set,
[ 30 ]
time are shown in the display
After the set time runs down, the product turns
off automatically .
. NOTE: When the product has been turned off
by the timer, End is shown in the display
If no button is pressed within 5 seconds after
[ 3 ] 22 ] [
was pressed, the timer setting will
be aborted .
˜ Overheating protection
The product is equipped with overheating
protection, which automatically switches off
the heating element in the event of internal
overheating . The fan continues to run to speed up
the cooling of the product . As soon as the product
has cooled down, the heating element switches on
again automatically .
˜ Replacing the battery
Replace the remote control's
the signal reception weakens .
Follow the illustration on the back of the remote
[ 20 ]
control .
Slightly press side lock of the battery
compartment
Remove the old battery .
Insert a new battery (type CR2025) with
correct polarity .
Push the battery compartment
˜ Transport
m
WARNING! Do not move the product while it
.
is in operation or cooling down .
Carry the product by the provided handle
only .
.
22 ] [
to confirm or wait for
and the remaining
6 ] [
20 ] [
battery as soon as
21 ] [
to pull it out (Fig . C) .
21 ] [
shut .
.
6 ] [
.
14 ] [
GB 15